Installation instructions
Organise each part of the lamp for easy assembly as shown in this photo.
(Place the pieces on a surface where there is no risk of damaging the paintwork)
First, finish assembling the body of the lamp using the 2 threaded end caps, the stem and the decorative end cap.
Install the dome, fitting the notched washer and nut.
Make sure you tighten it firmly.
Then place the metal plate in position, and fix it in place using the screws supplied.
Make sure the metal plate is flush with the bottom of the dome and screw tight.
You can now install the lampshades.
Peel off one side of the double-sided 3M tape and attach it to the metal plate.
Make sure it is centred and adheres to all parts of the metal plate.
You can now fix the lamp to the wall. Make sure the surface is clean, dry and as smooth as possible.
Mark the spot where you want to fix the lamp, peel off the double-sided tape and place the lamp on the wall using strong, even and constant pressure for 2 minutes.
Your lamp is now firmly attached. You can now install the bulbs.
If you want to charge them later, simply remove them without unscrewing them, using the magnet, and recharge them using the cable supplied.
If you want a permanent fix, you can use the fixing kit with screws and fixing plugs that we include in every set.
Are you satisfied with the quality of our products?
Discover all our other products and take advantage of the promotional code shown on the thank you card right here :